20T Rubber Molding Curing Press Vulcanizer Machine

20T Rubber Molding Curing Press Vulcanizer Machine   Introduction The ZB-910 small-scale experimental vulcanizing machine can be used for vulcanization or molding of rubber products, plastics, composite materials and other synthetic materials, and can also be used for pressing standard test pieces for tensile, impact and other tests. This equipment features convenient operation, small floor space and low energy consumption. It is particularly suitable for use in factories and school laboratories without three-phase power supply.   Advantage The machine is lightweight and only requires a regular single-phase power supply. Its installation and operation are relatively simple. The pressure gauge shows the pressure, which can be adjusted freely within the range of 0 to 20MPa. The thermometer shows the temperature, and the temperature within the range can be set arbitrarily.   Technical parameters Nominal clamping force 0.2MN (i.e., 20 tons) Hot plate size 300*300mm Hot plate spacing 120mm Number of working floors Single layer Temperature range RT-250℃ (can be customized) Temperature fluctuation ±2%℃ Maximum hydraulic pressure 20MPa Total power 4KW Loading method Manual loading Power Supply 220V 50Hz Dimensions 450*450*1000mm Net weight Approximately 220Kg  

25T Silicone Flat Press Moulding Vulcanizing Machine

25T Silicone Flat Press Moulding Vulcanizing Machine   Applications The ZB-910 small flat vulcanizing machine is suitable for pressing various molded products, such as rubber and plastic, and is also applicable to thin sheet products.   Performance characteristics The main unit is of a four-column integral structure, with an upward pressing type. It is divided into three parts: the main unit, the oil tank and the electrical control box. The electric heating is controlled by an automatic temperature controller in three channels, which can be adjusted freely within the range of 20 to 200 degrees. Once the temperature is reached, the circuit can automatically maintain a constant temperature. After the set vulcanization time is achieved, an automatic alarm will sound.   Main Technical Nominal clamping force 0.25MN (i.e., 25 tons) Hot plate size 350*350mm Hot plate spacing 150mm Number of working layers 2 layers Maximum hydraulic pressure 14.5MPa Maximum stroke of the plunger 250mm Heating power 7.2KW Motor power 2.2KW Dimensions 1250x550x1420 mm Net weight Approximately 1T Note This equipment requires 25 liters of 46# hydraulic oil, which should be prepared by the user.