30L Vacuum Planetary Mixing Machine for Battery Slurry & High-Viscosity Materials

Ⅰ. Equipment Features:

Applicable Scope

Once the mixer finishes preparing the slurry, tilt the 30 L bucket onto the elevator and attach the mixing head to convert it into a slurry transfer tank. This setup allows for the transfer of slurry from the mixing room to the storage and coating areas. The slurry is then delivered to the main tank or coating head through conversion fittings.

Ⅱ. Main Technical Parameters:

Container Parameters

l Design total volume: 45 L

l Effective volume: 15–30 L

l Container inner diameter: 400 mm

l Container inner depth: 360 mm

l Contact material: SS 304

l Temperature-jacket configuration: single-layer jacket on tank wall for heating/cooling; single-layer jacket on bottom for heating/cooling

l Jacket connection: G 1/2″ quick-connect union, rated ≤0.4 MPa

l Jacket circulation: customer-supplied; inlet water ≤8 °C, flow >15 L/min

l Discharge port: one G 1″ three-piece ball valve at bottom; with 1″ standard ISO quick clamp

l Operating ambient temperature: –10 °C to +120 °C

l Mobility: mounted on casters

l Interchangeable with 30 L mixer bucket

Mixing Components

l Operating frequency: 50 Hz

l Mixing power: 0.75 kW (one unit)

l Mixing speed: 48 rpm (fixed)

l Impeller diameter: 380 mm

l Impeller type: inclined-paddle spiral

l Impeller material: SS 304

l Impeller tip speed: 1.0 m/s

l Number of impellers: 1

l Number of shafts: 1

l Clearance from impeller to tank wall: 10 mm

l Clearance from impeller to tank bottom: 8 mm

l Principle: unique inclined-paddle design prevents material sedimentation

Top Lid Components

l Lid material: SS 304

l Feed inlet: one ISO standard 1″ quick-connect

l Viewing ports: two DN50 tempered-glass sight glasses

l Vacuum module: one set with G 3/4″ connections (vacuum and vent)

l Mechanical vacuum gauge port: one Y60 mechanical gauge

Control System

l Electrical cabinet: houses inverter and low-voltage components

l Manual control panel: includes buttons, knobs, instruments

l Power supply: AC 3×380 V ±5%, 50 Hz

l Control method: electrical control

l Operation: button + knob panel on electrical cabinet

l Emergency stop: one button

l Start button: one

l Stop button: one

l Worklight switch: one

Safety Interlock System

Emergency stop: pushes E-stop, machine halts immediately; no further operation

Other Notes

l Oil seals: domestic brand; static seal by O-ring, dynamic by mechanical or skeleton seal

l Lubricant grease: domestic

l Valves: domestic

l Vacuum requirements: customer-supplied vacuum system at 8 L/s (2×8)

l Vacuum retention: –0.098 MPa, must hold >–0.085 MPa for 24 h without leakage

l Main power: >1 kW

l Total weight: approx. 250 kg

l Dimensions: L 594 mm × W 560 mm × H 1420 mm

l Color: off-white

l Load-bearing floor: 400 kg/m²

Ⅲ. List of Randomly Supplied Wear Parts:

Ⅳ. Supporting Conditions: